We use Kroil here also. It is expensive but, it is very good at removing residue and leaving behind a clean oiled surface. We use it when assembling...
That's it D-66', the oil is forced under pressure through the filter and out the little hole down the hollow bolt and out the bottom. Don't let that...
I worked on the Jeep this afternoon. I removed the grill, and radiator. I am sure it is normal practice to fight the rust, paint and undercoating on...
JW I don't often do this but... Do not buy the complete electronic distributor, from anyone. They are all a Chinese manufacture that seldom works. I...
Getting close to installing distributor on this F134 rebuild. I have a standard setup with points, but have read good things on the Pertronix mod as...
THANKS SO MUCH!!! I pulled the cover off and sprayed penetrating oil on the springs and let is soak down the stems. I did not try to turn the engine...
The cover on the top. You have 4 overhead intake valves on the F-Head and 4 in the block exhaust valves. When you pull the top cover you will be able...
I poured a quart plus of ATF in the spark plug holes. I plan to let it sit over the week end. Sunday or Monday I will cut the fan belt off and remove...
AJ-MJ, assuming you have an F-Head in the 3B, it sounds like a valve is stuck open. Pull the valve cover and look for a valve that is stuck down or a...
Mike's carb parts as also a good source for parts. I use him quite a bit. A call to him will get you a lot of information about ethanol in your fuel....