48 4cyl jeepster engine install
Am I correct to assume if the pivot on bell crank and on the frame align w/ the clutch release shaft that the eng has to mounted correctly? To accomplish this I have had make brackets to move the front mounts back 1" now with that done the pivots are 5/8" out of alignment vertically. Any suggestions? All mounts seem correct from parts book. Thx, tomc5
Jeepster - Rare and Unique
Quote:
Originally Posted by
tomc5
Am I correct to assume if the pivot on bell crank and on the frame align w/ the clutch release shaft that the eng has to mounted correctly? To accomplish this I have had make brackets to move the front mounts back 1" now with that done the pivots are 5/8" out of alignment vertically. Any suggestions? All mounts seem correct from parts book. Thx, tomc5
Tom:
Jeepsters are rare and unique critters. They use a smaller frame than the trucks and have different proportions than the CJ's. Unfortunately, what you are asking is a question not a lot of folks on this forum have ever encountered. Have you looked for any forums or bulletin boards that cater more to Jeepsters than the utility grade vehicles we work with here?
Good luck...