Results 1 to 3 of 3

Thread: CJ2A, Template For Floor Panel Holes???

  1. #1
    Junior Member
    Join Date
    Sep 2018
    Location
    Huntington, IN
    Posts
    12

    CJ2A, Template For Floor Panel Holes???

    My 48 2A has had new floors installed on the tub before I bought the project, and the only hole is for the gear shift levers. Are there templates for the gas, clutch, brake pedals?

  2. #2
    Junior Member soutdere's Avatar
    Join Date
    Aug 2013
    Location
    Idaho
    Posts
    7
    When I went through my 2A, all I had was the old tub to estimate/measure off of. I cut some holes, and then burred them out to fit once the tub was bolted in place. It does not look pretty. The rods still rub and squeak like crazy! I am wishing I had asked the same question here and found an answer. Happy hunting.

  3. #3
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    3,570
    There is not an exact measurement for the clutch, brake, and gas reliefs. I would recommend setting the body on the frame and marking the exact position of the arms, and the linkage for the gas. If you do not want to set the body on, then you can use some heavy cardboard to lay out the floor. Make sure you drill a big enough hole to allow the full range of movement for the clutch and brake pedals.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •