I am replacing the oil lines on my 62 CJ5 4-134 F head. I'm still using the oil bath and filter canister which has the two oil lines. One to the timing cover and the other running down to the bottom of the block which terminates by the fuel pump. It looks to me that the only way to replace the line near the fuel pump is to remove the fuel pump first. I could get an open end wrench on the line but have no room to turn the wrench. I think a crows foot would be too thick as well. I was just curious if any of you all knew of any tricks to avoid removing the fuel pump. In case you're wondering, I'm swapping the old flared tubing lines for flexible ones.