Master Cylinder Locate

[Dave Klein]

Hey bm... This is Dave and I never sent any pictures of my frame..........gm is confused?? lol !!

[bmorgil]

Hahahaha! gm works too hard and stays up too late!

[gmwillys]

True. Bmorgil's PeeJ's pictures where what I saw. Sorry Dave, my mistake. Trying to multitask and eat brunch didn't work out for me there.

[Dave Klein]

On a different subject,,,Has anyone designed a better way to put the front hub on instead of the double nut lockwasher system?? There must be a better way ?? It does work but I think it's a PIA?? Also, do I fill the knuckle housing with the corn head grease. Or do I leave a little room for expansion?
The master cylinder mount will be good now as soon as I weld a 1/2 thick plate on the frame to mount it.
Thanks, Dave

[bmorgil]

Lots of font hubs are on that way. It was and still is the way the beam style is usually set up.

You fill the knuckle to the level of the plug and stop when it runs out.

Show us some pic's of that project Dave!

[Dave Klein]

I just got the corn head grease from Amazon.....It looks like it could be used with a caulking gun but there is no tip on the tubes.....So I just put in my grease gun??
Then pump till it comes out the plug? I need a battery powered grease gun.....
I can't send any pics on my flip phone !! I'm pretty much old school !!! Sorry bout that !!!
Dave

[bmorgil]

Go for it Dave! You have the process. In the grease gun it goes.