I gave up the search and fabricated my own that does not look stock. Bending the wire seemed too much work and I don't own an acetylene torch. I took a piece of 3/16"x1" flat and drilled two holes in it for the 1/2" clearance 1.5" apart. I bolted in the holes two 5/16" bolts with the heads cut off. I set up the door and held it shut with a clamp and welded a small piece of 1/8"x1" flat welded in between the bolts where the door was held closed by the latch. The picture is the result. It works nicely and is slightly adustable.
Reply With Quote