I haven't posted in a while but I'm still plugging away. Just finished a refresh of the T90 and Dana 18. It was fairly straight forward and I didn't run into any real issues. I do have a couple of questions, though. On the transfer case, the shift rods are easy to move back and forth without the detent balls and springs. After installing the ball and spring to each side, the 4 wheel drive shift rod moves without too much effort when you grab the end of the rod. On the high/low shift rod, I can't move it at all by hand. Any ideas on what might be the issue here? The next question involve the T90. The shift fork for second gear has a little play in it and if I shift into second gear and remove the shift tower, I have a small gap (1/16" or so) between the sychro sleeve and the second gear. From what I've read and watched online, this gap can cause the transmission to pop out of second gear. Any suggestions?