Activity Stream

The synchronizer wears on the inside of the brass ring. As it wears it sets deeper and deeper into the gear. Eventually it sets too deep to function...

I have used a very high quality red oxide primer, i belive it was the same red oxide as used on ships! the top coat came from a paint supplier on...

Hello All the components are new, and all brought from just one supplier here in the UK. It all feels to tight if that makes sence, i had a...

That is pretty!

Thanks for re-posting for the Tech Forum! More good stuff. This will save someone time and money.

Steady as she goes Steve. It is looking like its getting ready for battle! Looking good.

Damn you outta be Happy it turned out Great Steve!!!!!

The Oring Store was a Great suggestion test!!!! I’m all the time looking to replace one and the closest place around me is Akron Bearing, 30 minutes...

I’m kinda thinking along with bmorgil it looks like the hub may be in backwards or maybe one of the springs that hold the sliders in is giving you...

Looking great!

Something is amiss there Steve. What components are new? The collar that slides on has a "long side". The long end goes on to the front. In the...

Looks great! What/ whose paint products are you using?

thats what i thought, when you say the hub should be right against the gear, I have tried the gear both ways and the gap it the same. If i stand...

For those who might need to do this in the future, the size I found that worked the best was: Dimensions: 2-1/8"ID X 2-5/16"OD X 3/32"CS (these are...

Therefore, I started looking around and discovered The O-ring Store https://www.theoringstore.com/store/ where you can buy just about any O-ring that...

The sychro ring is not seating all the way down on second gear. That is going to cause the synchronizer hub to set a little away from the gear. The...

Thank you sir

Yeah, not sure why it disappeared, but like you say, it isn't the first time it's happened. Sure, I'll repost in the Tech Section. Thanks!

I think I finally have a picture of what I need, see attached. Thanks to all for your help.

Thanks. There appears to be a lot of information for the CJ's, but very little for the trucks. I know the PTO for the CJ's is different than the...

I tried rotating a picture before posting using editor on the phone one day. It took 5 tries rotating 90 degrees and saving before I got the picture...

The folks over at FarmJeep have compiled some info sources that may help you in getting to the bottom of what drive shaft you need; ...

Great start to the overhaul process.

I still like the black handles. Looks great against the orange.

Got some keys made for the Willys;-) Sent the locks to town and had some keys ‘impressed’. 3weeks but he got it(never had a working key to...