Activity Stream

Guys: I just brought home an early 1950 Willys Wagon that I hope to bring back to life. The engine is out and I was given two engines for the...

Im installing a new bell crank bracket on my CJ2A..... I took measurements off the old one as far as center to center of pin and figured this would...

Hi all, I just got my transmission separated from the transfer case and got to take a good look at it. My jeep was parked for many years, and it...

New to Forum. My second Jeep, first Willys Overland Truck. 52 and hopefully a project i can handle. Lots to do and trying to find a starting point....

Good day, all -- I was thinking about removing some of the leaves (leafs?) from the spring packs on the old 3a. A few at each corner. The idea is...

Hi all – checking in here first time. Picked up this ’49 CJ3a close to home, promised my wife it wouldn’t sit more than a week in the...

Gday guys, Ive got this hubcap here, been in the family property shed since the 1960s, I found it at an abandoned wreckers yard just lying on the...

I just put in my new transfer case and transmission along with installing body gaskets on the frame. The Tub rests right on top of the rear PTO...

I have searched the forum and other places and while I find some topics, I do not find any thing that confirms what the engine and compontents paint...

Hello, I just installed the conversion kit from 6V to 12V on my CJ2A. Anyone have direction on where to get an alternator adjustment bracket...

Gday guys, Im Bob, never owned a Jeep but in my older years now Im on the lookout for a 1990s Wrangler convertible, ex aircraft helicopter engineer...

I’m rebuilding a 6-161L engine for a 1949 cj3a and I can’t find pistons anywhere. No luck. . 3.125" is stock bore and we need 0.060" over piston. I...

ISO information about the cowling vent on my '52 Truck. When i got it, the cover was there but noting inside. Does anybody have a diagram, picture,...