I am out on that one gm! I have seen toilet paper dissolve into a paste. I would be extremely concerned the volume of oil through the motor might be...
We use Kroil here also. It is expensive but, it is very good at removing residue and leaving behind a clean oiled surface. We use it when assembling...
That's it D-66', the oil is forced under pressure through the filter and out the little hole down the hollow bolt and out the bottom. Don't let that...
I worked on the Jeep this afternoon. I removed the grill, and radiator. I am sure it is normal practice to fight the rust, paint and undercoating on...
JW I don't often do this but... Do not buy the complete electronic distributor, from anyone. They are all a Chinese manufacture that seldom works. I...
Getting close to installing distributor on this F134 rebuild. I have a standard setup with points, but have read good things on the Pertronix mod as...
THANKS SO MUCH!!! I pulled the cover off and sprayed penetrating oil on the springs and let is soak down the stems. I did not try to turn the engine...
The cover on the top. You have 4 overhead intake valves on the F-Head and 4 in the block exhaust valves. When you pull the top cover you will be able...
I poured a quart plus of ATF in the spark plug holes. I plan to let it sit over the week end. Sunday or Monday I will cut the fan belt off and remove...
AJ-MJ, assuming you have an F-Head in the 3B, it sounds like a valve is stuck open. Pull the valve cover and look for a valve that is stuck down or a...
Mike's carb parts as also a good source for parts. I use him quite a bit. A call to him will get you a lot of information about ethanol in your fuel....