Activity Stream - Willys Jeep Forum

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Filter by: Last 7 Days

Clear All

Older Activity
Today, 01:07 PM

LarrBeard started a thread Ham's '48: Home Coming 2024 in Willys Jeeps - General Discussion

Old trucks just seem to go with pretty girls ...

see more

0 replies | 2 view(s)
Yesterday, 06:52 AM

bmorgil replied to a thread Very Worried in Willys Jeeps - General Discussion

You should not see any coolant at the head studs. If you do it has to be coming from around the stud at the gasket or the threads in the block are...

see more

3 replies | 1402 view(s)
10-06-2024, 09:13 PM

steve welder replied to a thread Very Worried in Willys Jeeps - General Discussion

I got a machinist straight edge and there is what I think is excessive clearance right next to #3 cylinder near the water jacket. How that is...

see more

3 replies | 1402 view(s)
10-02-2024, 08:18 AM

bmorgil replied to a thread sealant on head studs in Willys Jeeps - General Discussion

Steve, again no sealer on the studs, they do not enter the water jacket. They are installed finger tight only. Reference the service manual. There...

see more

1 replies | 2231 view(s)
10-02-2024, 08:16 AM

bmorgil replied to a thread Very Worried in Willys Jeeps - General Discussion

Steve, I think your OK. I thought way back, in one of your threads, you mentioned bolts instead of studs were in your engine. I have said it a few...

see more

3 replies | 1402 view(s)
10-01-2024, 07:03 PM

steve welder started a thread Very Worried in Willys Jeeps - General Discussion

If you read my radiator post you would have seen that I had coolant being pushed out of radiator and I found coolant in #3 cylinder. We thought...

see more

3 replies | 1402 view(s)
10-01-2024, 06:48 PM

steve welder started a thread sealant on head studs in Willys Jeeps - General Discussion

Whats the consensus on best sealer for head studs into block. Ive used Permatex #2 but open to anything better ----Thanks

see more

1 replies | 2231 view(s)