Activity Stream

Baby steps……. :)

Yes. I'm happy the motor isn't seriously hurt. And hopefully I can get a long time out of it without problems. I thought it was weird that some bolts...

I thought I might finally get this transfer case reassembled but it isn’t going to happen today. The shift rail seal from Crown rolled the lip when I...

Kaiser Willys sells copper gaskets for the bolts but I gave up asking on how they are installed. Gasket, flat washer then bolt makes the most sense...

That's about as good of a situation as you could ask for! Interesting the head stud nuts were that loose.

Yes they will leak. Spray them each with High Tack. Some of the bolts in the case will also all leak if they penetrate the case and enter the lube...

I thought a while back someone was talking about what about what to seal the transfer case rear bearing cover shims with. I can’t find the post. I...

So over the last few weeks i reassembled the oil pan after confiriming the bearings/ wrist pins are good. I then set valve lash and finised putting...

I need to add lube to my list.

The first thing that pops into my mind for grinding gears after a fresh reassembly is clutch adjustment. The second is something did not get...

That is looking great. You are going to be an expert at early Jeep body work!

Yes if you overfill it it will definitely leak from the original front input shaft seal. Remove the fill plug from the transfer case and the...

The floor replacement was easier than the dent repairs in the rear quarters and this is my first bit of body work I have ever done so it didnt come...

Thank you! Been slow in responding because I broke my kneecap about 10 mins after I made the last post! LOTS of memories and we are just getting...

Here Here gm! Thank God for our Veterans who gave it all. Everyday of our freedom is because of them. A debt that cannot be repaid.

That interior looks perfect. Good job!

The statement made about "priming" b4 PCing had me a little confused so I called the guy that did just about my whole project and he said if it is...

Great Job JB!!!

Nice jb! That is really a nice passenger area. That Monster is going to be the star of the show!

Baby steps….but a little more progress. Still need to button it all up to make it look right…

Hopefully we will get TJones to speak of the process he went through on his. It is 100% powder coated. Here is his project. ...

Man, Larry, that rust looks horrible! I'm sure you weren't happy to see that. I bet they will look great when you get them back. In any case,...

You have to love the need to test. Somehow, someway, no matter the potential banning from the kitchen. If you have the Heat Riser operational...

I did the old stovetop test before replacing my puck style new stat with this old flap style. Started opening at 160 and fully open at 180. With...