Activity Stream

The only add I have on my build is the glove box is made out of card board, I was able to get a plastic glove box for the '48. It was a great...

Just read a few threads. This forum has great knowledge. Thank you. The only add I have on my build is the glove box is made out of card board,...

Wow! Job done? Amazing.

The Wrangler looks nice too ...

It's kind of funny to look at that. Those pedals and such look exactly like the one's I've been working on. I guess things didn't change much over...

Looks really good.

Today, the Wrangler is done. Spent the day polishing up the loose ends and fogging up the final paint. I'm happy with the final product. The long...

True. My wagon body has been in the garage for a couple of years on saw horses. All I need to do is install new floors up front and repair the rear...

A. The lower left hole looks to be a bit out of round like someone put it in with a drill bit as an after market modification, but the top hole,...

On Jeep projects nothing goes as as fast as you want it to. Experience has taught me that if it goes fast - you'll probably have to take it back...

One thing we've learned is to never say "Never". But, the M38A1 was a 24-volt vehicle. It used two 12-volt batteries in series to get the...

Thanks boys. Yes, gauge thickness is important. Will do my due diligence. Here is a picture of the dash in question and as you can see, the PO/s...

SPENT MUCH OF THE DAY DOING THINGS THAT NEEDED TO BE DONE BUT JUST WAS TOO LAZY TO DO, BUT DID THEM TRIMMED PLATE ON TOP OF BOOT FOR SHIFT LEFER...

gmwillys, Do you think he has a 24 volt regulator in a converted 12 volt Jeep? Was there a 12 volt M38A1? How did they get the 24 volts?

I am not sure the one KW has isn't really a replacement. You may want to call them on that. Almost everyone is selling the stuff from Juan in Puerto...

Shop around on the best vendors. KW does offer some parts that are stamped or fabricated in the US. Anything Omex is generally cheap all around. ...

Bmorgil hit the nail on the head. The caps need the press fit for long life on all parts.

The starter is a 6 volt starter, and as Bmorgil said, leave it in because it will live just fine on 12 volts. The regulator may need some attention,...

I am flush with spot weld cutters from my last '66 Bronco. The page that B points out states dash cover. I want the old one gone and the new one...

Bmorgil is correct. I recommend purchasing a spot weld cutter from Woodward fab. They are worth the money for quickly cutting spot welds.

Yes. Spot welded in. There is some bracing also welded to it. It kind of slips in behind a lip in the cowl. ...

It would be cool that's for sure. Because of the flat head design, it would be kind of like an "Underhead Hydraulic Cam" instead of an "Overhead...

The 6 volt starter seems to perform nicely with 12 volts. There are some posts here about that. Many use the 6 volt starter on 12 volts. I was...

"Did you think of this after you put the Bourbon in the coffee, Sir? " No was just idle thinking, saw so many conversions for motorcycles just...

. More pictures.

Thank you for your posts, however I seem to have some difficulty posting pictures. I did learn (told you I was new) that the charging system...

gm's all over it. It could be done but the criteria of super expensive comes into play. If you could find a lifter that would fit, you would need the...

This is a tough one. Only because a high quality part may be hard to find. I had the same issue with my right front axle shaft. First, you are...