Activity Stream - Willys Jeep Forum

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

10-01-2024, 06:48 PM

Whats the consensus on best sealer for head studs into block. Ive used Permatex #2 but open to anything better ----Thanks

1 replies | 2019 view(s)

10-01-2024, 07:03 PM

steve welder started a thread Very Worried in Willys Jeeps - General Discussion

If you read my radiator post you would have seen that I had coolant being pushed out of radiator and I found coolant in #3 cylinder. We thought...

2 replies | 541 view(s)

Yesterday, 09:13 PM

I got a machinist straight edge and there is what I think is excessive clearance right next to #3 cylinder near the water jacket. How that is...

2 replies | 541 view(s)

10-02-2024, 08:18 AM

Steve, again no sealer on the studs, they do not enter the water jacket. They are installed finger tight only. Reference the service manual. There...

1 replies | 2019 view(s)

10-02-2024, 08:16 AM

Steve, I think your OK. I thought way back, in one of your threads, you mentioned bolts instead of studs were in your engine. I have said it a few...

2 replies | 541 view(s)

09-30-2024, 11:16 AM

“A person who never made a mistake never tried anything new.” —Albert Einstein. '56, if the fuel line was damaged, then it was probably ready for...

448 replies | 418767 view(s)

09-30-2024, 07:28 AM

A. Every one of us has, at one time or another, managed to split a gas or oil line while we do something else on the engine. That's not being an...

448 replies | 418767 view(s)

09-30-2024, 07:22 AM

It should have a spring and a valve in it 56'. They were serviceable back in the day. Some "bubba's" took the spring and valve out and threw them...

448 replies | 418767 view(s)