Activity Stream

Stuck back on a upper shelf. Short guys need step stools. Bought this Jeepster with 500 miles on a rebuild/hotrod alter. Came with parts and the...

Did you have it stuck back in a box that you hadn't searched through, or did you find a source for it somewhere?

That sounds like a fun new project for you! Welcome

I have found the part I thought was missing, mine has been chromed. Thank you to all who gave some really good info. Now I need to order the...

Just like Bmorgil said, Speedy sleeves have saved the day on a lot of worn seal surfaces. Now a bearing surface a sleeve will not work, because the...

You can use the SKF chart attached, or there are some others on line for the correct sleeve. It should be a 99118. The best price almost always seems...

gm breathes life into her! Nice gm, keeping those old rigs running!

The adjuster was lose, and was backed out on three rockers. The only thing that saved the top end was that the pedestal studs were lose as well. ...

Larry here is a plastic one with an outlet. https://www.summitracing.com/parts/rnb-61123 Or you could use an oil pan drain. There are a few...

That lil' D12 is so freakin' cute. It looks like a tractor only a lot smaller.

I would say the weekend is done! Man that is some serious lash under that rocker. Whats up there gm? Looks like the valve didn't make it home or...

Welcome to the forums! Looking forward to your build thread

Why don't I get anything done on the Heeps? Here are two reasons from this weekend. The first is a new to me S10 with a hurt 2.2, (broken timing...

If you want good info on specific parts or processes, go to threads by Pelogo (RIP), LarrBeard, gmwiĺlys, TJones, and bmorgil and equally good...

Ever been four wheeling in the desert with a geologist using a pick like the one in Shawshank movie except bigger and better? Maybe you pull over...

Thank you for creating an update and for sharing tips on how to do it.

Keeping Our Cool - Revisited In the last post on this I made the comment: "Now I just need to change out that dripping, pizzling cheap plastic...

After sitting 40-years, I suspect you are going to find a lot of seals that leak. The '48 truck sat 35-years and we just replaced every seal we saw....

I started her up again this morning and I can now run it at ideal, and it accelerates nicely, but sometimes after acceleration it wants to stop. ...

Worse than a MOPAR knock off, I was nonfunctioning. Weepy, wistful, and worsening. You may think I’m overreacting. But you’ll remember this, and...

Good news indeed dg! A few things can cause a rattling sound when a motor has been setting for 40 years. The most common being rust and build up in...

Well the fuel pump was back ordered and took a couple of week to get here. It arrived today and I installed it a fired her up. She ran pretty good,...

An old jeep truck is something I’d never driven before. Never learned to drive one. Therefore I thought it would be a low skill level endeavor. It...

I took the channel off and I now see that there is a slight bend in that portion that is over the vent window. The portion over the window side...

Thanks for the replies. I know it'll be a big project, but I'm anxious to get started. I'll add some pictures soon.

Yes, that is the part. Looks like it has nothing to do with the top fabric. I think I will be doing a bit of fabrication work.

Yes, that is the part. A detailed pic would be great, looks like I will be doing some fab work. Don't plan to run side curtains, but ya never know....

Welcome Bowlingusmc! The following link will give you a good look for how the data plates are configured for a 2A. The CJ2A is stamped on the...