LarrBeard
01-27-2019, 02:42 PM
It’s winter in NE Indiana. A lot of people act surprised, but strangely enough, it happens just about this time every year. The high next Wednesday promises (or threatens) to be -7, with 30 MPH winds. Streets get wet, sloppy, covered with muddy snow and a mix of body eating salt thrown in for good measure. My truck doesn’t get to go out and play in that mess anymore - I take a lot better care of it than I do myself.
But, it does get started every week and I let it run until the thermostat opens up and things get really good and warm. I use a little starting fluid to get it going and in the last month I discovered a trick that has made starting it easier.
I spritz a little go-juice into the carburetor and let it sit for a minute – yeah, about 60-seconds by the clock. Then, I just hit the starter (ignition OFF) and crank the engine through about three or four times. 6-volt systems crank slowly, but I believe that by cranking this way, with no spark, the fumes of the starting fluid get pulled into every cylinder while at the same time the carburetor is adding some fuel vapors to dilute the ether. After the third or fourth crank through, I usually see some oil pressure on the gauge, so I know there is lube on the mains.
Then, I hit the ignition. It starts on the next TDC and picks up and idles out quickly.
Now, I do have a good battery and a tight engine, so your results may vary depending on your engine condition and battery.
Stay warm and keep an eye out for the idiots out there!
But, it does get started every week and I let it run until the thermostat opens up and things get really good and warm. I use a little starting fluid to get it going and in the last month I discovered a trick that has made starting it easier.
I spritz a little go-juice into the carburetor and let it sit for a minute – yeah, about 60-seconds by the clock. Then, I just hit the starter (ignition OFF) and crank the engine through about three or four times. 6-volt systems crank slowly, but I believe that by cranking this way, with no spark, the fumes of the starting fluid get pulled into every cylinder while at the same time the carburetor is adding some fuel vapors to dilute the ether. After the third or fourth crank through, I usually see some oil pressure on the gauge, so I know there is lube on the mains.
Then, I hit the ignition. It starts on the next TDC and picks up and idles out quickly.
Now, I do have a good battery and a tight engine, so your results may vary depending on your engine condition and battery.
Stay warm and keep an eye out for the idiots out there!