46 willys turn sgnals?

[KennJ]

46 willys did not have turn signals. Any body got a part number and place I can order some that would work?

[AmyB]

Hi! You can try this part on Kaiser Willys Auto Supply (http://www.kaiserwillys.com/) #640197 http://www.kaiserwillys.com/product/2090/willys-jeep-electrical-parking-light-assemblies-parts-accessories

New Replacement Parking Lamp Assembly (2 required per vehicle)

For early grilles with recessed style parking lights

Comes complete with pigtail wiring for turn signals. Provides an easy fix for cracked, melted, discolored, miswired parking light assemblies.

Fits:
46-48 CJ-2A

[KennJ]

Hi! You can try this part on Kaiser Willys Auto Supply (http://www.kaiserwillys.com/) #640197 http://www.kaiserwillys.com/product/2090/willys-jeep-electrical-parking-light-assemblies-parts-accessories

New Replacement Parking Lamp Assembly (2 required per vehicle)

For early grilles with recessed style parking lights

Comes complete with pigtail wiring for turn signals. Provides an easy fix for cracked, melted, discolored, miswired parking light assemblies.

Fits:
46-48 CJ-2Athanks
for the information, I will check it out

[KennJ]

I am not sure all I need for the CJ2a, I would think a blinker assembly, front and rear lights. So would I have to run different lights on the front and back different than the original that is on the jeep? The jeep has been converted to 12 volts.

[AmyB]

I would give Mike at Kaiser Willys a call 1-888-648-4923 Mon-Fri 9-5 EST and he will go over everything you need.

[dave351cid]

i was talking to a guy the other day at a swap meet that sells led bulbs that will fit into your parker lights and will flash orange when used as turn indicators or white when used for parkers. he specialises in reproduction and led lighting.

i didnt follow up the details much because my `62 model truck was factory fitted with both white parkers and seperate orange indicators.

i am in Australia but i imagine if we can get them here then they would be available in the USA. just have to find who sells them.

[JeepCJ5]

Putting turn signals on any old jeep is simple...change the front park lamps to dual filament bulb socket units and that should be all the modifying that's needed....match the appropriate wires to the specific bulbs...it doesn't matter what voltage your jeep is...the turn signal unit that clamps to the steering column is just a switch...what does matter is that you must use the proper voltage flasher to make things work...just carefully read your instruction sheet and it shouldn't take you any longer than a couple of hours to begin and complete the job...I just put a new wire harness in my 56 CJ, including a new turn signal switch...it took a single weekend to do everything...good luck.