still sore from moving the rear end .. but now hanging parts, rear end assembled, not all tight but hanging thereAttachment 1835Attachment 1836
Printable View
still sore from moving the rear end .. but now hanging parts, rear end assembled, not all tight but hanging thereAttachment 1835Attachment 1836
Another Harbor Freight item, (I don't work for them, just I tend to be cheap) are the furniture casters. Doing differential work, they make life a whole lot easier. I have all sorts of different cast or cart set ups to move my crap around. My wagon is set upon a cart that started off as a man lift base. The body is easily moved around, but is stable enough to perform body work upon. I work alone, so I have to figure out how to do all this by myself. Doing all this work on our seasoned iron is only worth it if you are able to enjoy it when it's finished.
Attachment 1837Attachment 1838
Surplus stores are an excellent source of parts and information. The guys that have been in business for years, have seen and heard of where all the good stuff is hiding. You did well on your purchase. I'm going to look into some of my notes to see if I have anything on your vent line conundrum.
built one to push engine around, probably need one for the tub
Here is a descent diagram on the routing of the vent lines on an A1. The link to the forum is as follows; http://www.willysmjeeps.com/v2/modul...wtopic&p=52169
On the same site (Willys Military Jeeps), there is a gentleman that is selling vent lines. He has them by part number, from the SNL G758 manual.
http://www.willysmjeeps.com/v2/modul...ewtopic&t=4806
GOT IT AND THANKS!!!! Now am trying to also figure out the clutch assembly, took the bell housing off and did find one issue. one of the bolts holding pressure plate on was missing and the reason missing is damn thing broken off in flywheel. Oh Joy another broken bolt to spend several hours doing. Now i have seen the pictorial diagram and it is helping with the linkage however am cloudy on the throw out bearing.. any good photos out there of this. there is a fork and i have two of them used in the control cable, but what does the fork pivot on? BTW the clutch i looked at is in great shape, really do not think i need a new one, same with pressure plate. springs are monster stiff
ALWAYS SOMETHING
felt that things were going okay, got a ton done, and then wanted to pull last drum, the other three came off without too much trouble, NOW THIS SOB WONT BUDGE, STARTED AT 10 AM AT 6PM STILL BEATING ON IT,,, IT DOES MOVE JUST WONT SLIDE OFFAttachment 1885
Do you have the adjusters for the brake linings/shoes turned to pull the shoes off the drum? I have had shoes/linings hang up on a little groove at the edge of the drum, especially if the drum needed to be turned.
i believe that they are loose, but damn thing is loose but just will not come off The other three drums hardly showed any wear at all... next step C4
Kaiser Willys sells a hub puller that is worth its weight in gold. I have used one on several sets of axles, and have not had one that would not come apart. Some were so rusted together, that a rose bud torch head was needed to warm things up enough for the hub puller to work effectively.
https://www.kaiserwillys.com/categor...86-jeep-willys