DOT 3 vs, DOT 5 and 5.1 rake Fluid
Quote:
Originally Posted by
AJ-MJ
Is the DOT 3 brake fluid satisfactory or should I use the DOT 5? I understand the benefits of the DOT 5, I am just wonder the use the the old jeeps.
The main advantage of DOT 5 fluid is its higher boiling point - something you might have concerns about in your German Mercedes or other really high performance car, but probably not in a CJ.
Here is a cut and aste from a pretty good explanation of the differences:
DOT 3 is always the cheapest option—DOT 4 is about 50% more expensive than DOT 3 and DOT 5 is about two times more expensive than DOT 4. Some owners mistakenly assume that the higher cost of DOT 5 equates to better performance, but this is not always the case. In fact, sometimes the exact opposite is true. To get a better handle this, we need to take a crash course in chemistry.
Common brake fluids such as DOT 3, 4, and 5.1 are mixtures of glycols and glycol ethers while DOT 5 is silicone based. DOT 3, 4, and 5.1 are hydroscopic, which is a fancy way of saying they absorb water. We know what you are thinking--brake line moisture is evil! It is true that we try to keep our brake systems "dry", but over time, even a buttoned up brake system with tight seals and new lines absorbs moisture. The key here is what happens to that moisture after it enters the system.
DOT 5 doesn’t absorb moisture. But even though DOT 5 doesn’t absorb water, it can’t/won’t prevent moisture from entering the brake system. And since the water isn’t absorbed by DOT 5, moisture puddles and causes localized corrosion within the brake system. As funny as it sounds, DOT 3, 4, and 5.1 absorb moisture, which in turn eliminates the puddling that can cause corrosion. More importantly, when brake fluid heats up, water trapped inside the brake lines (but not absorbed by the brake fluid) is converted from liquid to vapor. Steam compresses easier than liquid. With this in mind, imagine barreling down the road at high speed and hitting the brakes. When the hydraulics sends DOT 5 fluid through a pocket of steam in the line, that drop in pressure creates a soft pedal . (Probably not a Jeep concern..).
Most folks know they aren't supposed to top off DOT 3 or 4 brake fluids with DOT 5, but don't know why. The answer goes back to the chemistry. Combining even trace amounts of a glycol-based brake fluid with DOT 5 can cause the two incompatible fluids to gel, resulting in poor braking. Converting to DOT 5 also requires thorough flushing and removing ALL traces of the old fluid to avoid seal damage.
This is another case with an Old Jeep where newer is not necessarily better.