Search:

Type: Posts; User: dgoodenow

Search: Search took 0.00 seconds.

  1. Replies
    23
    Views
    9,503

    Sticky: Thanks, but the regulator I have has screw...

    Thanks, but the regulator I have has screw adjustments. The only trouble was I turned the screw to the right and the volts went up, so I turned the screw to the left (no brainer) and the volts went...
  2. Replies
    23
    Views
    9,503

    Sticky: "But, I have another concern. You mentioned that...

    "But, I have another concern. You mentioned that the regulator had about 8-volts in and out. If 8-volts is where the electrical system is running, thatís pretty high if the battery has topped off its...
  3. Replies
    23
    Views
    9,503

    Sticky: That is great information. I tested the...

    That is great information. I tested the replacement regulator again this morning before I install it, and this time it read 2 ohms from ign to output. I think I was not making good contact before...
  4. Replies
    23
    Views
    9,503

    Sticky: I found a discussion online about this instrument...

    I found a discussion online about this instrument cluster voltage regulator. The discussion included a test procedure. It said the ign to case should read 42 ohms, and 0 ohms ign to output. The...
  5. Replies
    23
    Views
    9,503

    Sticky: Guys: After thinking more about the comments on...

    Guys: After thinking more about the comments on this page, I did a test. If I am getting about 8 volts to the temp gauge when the truck is running, and with a 6 volt battery, I should only get a...
  6. Replies
    23
    Views
    9,503

    Sticky: Thanks for the information. I have a used...

    Thanks for the information. I have a used instrument cluster with the attached voltage regulator, I will install that device and hope for the best. The voltage to the battery may be high because...
  7. Replies
    23
    Views
    9,503

    Sticky: Willys Truck Gauge Clusters

    Guys: I'm redoing a 1952 Willys stake bed truck, see attached, and I am having trouble with the temperature gauge. The truck starts and runs well, but after a few minutes the temp gauge pegs to...
Results 1 to 7 of 7