Search:

Type: Posts; User: scoutingranch

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    1,867

    Ahhh, cold beer and a Winston. Those were the...

    Ahhh, cold beer and a Winston. Those were the days. I'll pick up roll your own smoking when I'm eighty. I even had to quit dippin' Copenhagen. That was until I was out on a horse trip with...
  2. Replies
    17
    Views
    1,867

    Nice job Mr. Jones.

    Nice job Mr. Jones.
  3. Replies
    17
    Views
    1,867

    Thanks boys. Yes, gauge thickness is important....

    Thanks boys. Yes, gauge thickness is important. Will do my due diligence. Here is a picture of the dash in question and as you can see, the PO/s had their way with the metal, after market...
  4. Replies
    17
    Views
    1,867

    I am flush with spot weld cutters from my last...

    I am flush with spot weld cutters from my last '66 Bronco. The page that B points out states dash cover. I want the old one gone and the new one welded in. Is the gage thickness of the metal the...
  5. Replies
    17
    Views
    1,867

    Question about a dash

    Lads,
    my '50 cj3 has had the dash hacked up over the years. Oh' I can stitch weld the repair metal in the large holes but I found a new dash from a vendor. If my observation is correct, the dash...
Results 1 to 5 of 5