Search:

Type: Posts; User: Nemo von Klepper

Search: Search took 0.00 seconds; generated 57 minute(s) ago.

  1. Replies
    31
    Views
    30,676

    This is definitely something to keep in mind when...

    This is definitely something to keep in mind when I get to the point the engine stays running long enough for this to potentially happen... :confused:

    Speaking of vapor lock, I finally mounted my...
  2. Replies
    31
    Views
    30,676

    Thanks for that advice. So I was looking at some...

    Thanks for that advice. So I was looking at some videos about application. It seems the instructions require the tank to be rotated for 3 hrs to keep the sealer from pooling. I was wondering if this...
  3. Replies
    31
    Views
    30,676

    Thanks, that's good advice. I did a little more...

    Thanks, that's good advice. I did a little more research and it turns out a lot of boaters use Permatex Aviation Form-A-Gasket No.3 for this kind of problem. A pint can costs $8.
  4. Replies
    31
    Views
    30,676

    Thanks, I agree. I was going to add a sediment...

    Thanks, I agree. I was going to add a sediment bowl on my system with my current fuel pump until I realized the dual action has a sediment bowl and I would need that fuel pump for my vacuum...
  5. Replies
    31
    Views
    30,676

    Good luck with the rebuild. I had mine blow...

    Good luck with the rebuild. I had mine blow apart, but luckily they didn't take out an eye or get lost.

    So...
    I installed the pressure regulator to hang off the carb with a couple L brackets....
  6. Replies
    31
    Views
    30,676

    Ok, that's good info. I'm still in the process of...

    Ok, that's good info. I'm still in the process of getting this thing running. I've had the jeep sipping gas out of a gas can: plastic gas can> rubber gas hose> fuel filter> fuel pump> rubber gas...
  7. Replies
    31
    Views
    30,676

    Thanks, I've been off line a little while now,...

    Thanks, I've been off line a little while now, but I'm back.

    I absolutely agree about the fuel pressure regulator now. I ended up getting a Holley 1208, offered by KW. It has a range between 1 to...
  8. Replies
    31
    Views
    30,676

    Well, I managed to get it going again and it ran...

    Well, I managed to get it going again and it ran for about 3 or 4 minutes until my improvised Coke bottle gas tank ran out of gas.
    I couldn't get it started again. This is a multi variable problem....
  9. Replies
    31
    Views
    30,676

    It's Alive!!!! It ran for 30 seconds until I...

    It's Alive!!!!
    It ran for 30 seconds until I pushed the choke back in. I probably should have waited.3089

    It's still flooding, but at least I'm narrowing on the target.
  10. Replies
    31
    Views
    30,676

    So... According to that video, it's definitely a...

    So...
    According to that video, it's definitely a problem with the fuel not being closed off.

    I pulled the carb apart. This is what I can't figure out, the vast difference between the float...
  11. Replies
    31
    Views
    30,676

    Thanks, I recently rebuilt this carb, so the...

    Thanks,

    I recently rebuilt this carb, so the needle is new. The float moves freely, but when I pull the carb apart, I'll check to make sure it doesn't have fuel inside (?).

    I think I may have...
  12. Replies
    31
    Views
    30,676

    More Carter YF-938SD problems

    My CJ3B is finally showing signs of life.
    After going through recommended long dormant engine restart procedures, I started cranking it. The carb flooded badly, actually dripping over the side--at...
Results 1 to 12 of 12