Search:

A roll cage to the frame gets the Job done. Attached is a pic of the 2019 parade chase vehicle LarrBeard and I had just in case! A champion Rock Crawler.

I love that Truck! Can't wait to see it at the 2020 Jeep Fest. It sure looked good in the 2019!

There are a few good post related to this in this Forum. I have converted my 6volt CJ to 12volt. Having said that, the only reason I did that was because every piece of the original 6volt system had...

He made his choice Larry, he's living in the garage.

Wow that is some serious work!

Though the "TJ Cafe" is intriguing, how about we meet in Alabama? Have you seen the Northern Ohio forecast? It ain't pretty!

Adjusting the drag link is fairly easy. It will definitely cause slop in the steering if it is too loose. It is there to absorb road shock. On the bell crank end, turn the screw in all the way then...

Now that's showing off! Is that an engine lab or a garage or... perhaps a cafe?

Ha ha! That is too funny! My wife reminds me of the disappearing rear end scenario all the time.

If you have the front suspension all rebuilt, the wheels balanced and the toe set, and you aren't...

Yes you are correct The service manual focuses on how well the motor compresses during the first four strokes. If compression jumps up "quickly" it indicates good pressure. If it is slow to come up...

The Tightsteer is to help with a worn sector shaft thrust surface. You will know if you have a problem with this with a visual inspection. First you must be sure the steering box is in the center of...

Nice and, permanant!

Coffee and bourbon always both!

One thing to add... On the Pertronix ignition, there is an Ignitor and an Ignitor II. These ignitions use a magnetically switched trigger (not a magnetic pulse). This has a majior advantage and a...

There is no arguing your point on the "Points" gmwillys! To add to that, in the event of a HPEM the points will keep running! With the Pertronix the whole thing replaces the points plate. You even...

Ha ha! I love the nostalgia of the whole thing. That is going to be a sweet ride with air, cruisin' through the Pima McDonald's that's for sure. I think gmwillys has had some bad experiences with...

The wheel shimmy could be a few things. Tire balance will cause it. On a front drive/steer axle like the Willys, often it is the steering knuckle pivot bearings. If the preload gets too loose on the...

You've made some great decisions on the project okiemark. I am happy with the body kit from KW on my CJ3A. It did need some work to make it fit. I wrote about some difficulties I had with mine. I...

Last time? You mean on this go round I take it! It is a very old Willys, it may need you from time to time!

You can't get any better than that!

I think the hope was the transfer case would block everything? Well it looks like you are almost ready for a test ride.

Picture okiemark.

If it is on the side of the tube, it is probably for the brake line tee bolt.

It is chapter 6 in the Military Manual. It starts on page 114. https://documentcloud.adobe.com/link/track?uri=urn%3Aaaid%3Ascds%3AUS%3Acc44df5e-b547-48b1-9929-f4861a344c4d If this isn't what you...

I hate that when the thoughts creep in. Well lets hope for no leaks. My brother calls these 15 minute projects. Projects that turn into monumental events!

It is probably for a vent. Send a pic.