Search:

Type: Posts; User: CChris

Search: Search took 0.00 seconds.

  1. Replies
    14
    Views
    3,311

    After a lengthy delay to help with Spring cleanup...

    After a lengthy delay to help with Spring cleanup around the yard, I'm now back into the jeep. After examining several of your suggestions I've been able to get the jeep to start reliably after...
  2. Replies
    14
    Views
    3,311

    Thanks, Bob I've ordered a replacement...

    Thanks, Bob

    I've ordered a replacement ignition module and will close this thread with how it performs with the replacement once installed.
  3. Replies
    14
    Views
    3,311

    Thanks for your assistance. I've got 10.8 volts...

    Thanks for your assistance. I've got 10.8 volts between the coil (+ ) and the bat (-) during cranking.
  4. Replies
    14
    Views
    3,311

    In addition, I remeasured the resistance of the...

    In addition, I remeasured the resistance of the coil with nothing attached: 3.6 Ohms
  5. Replies
    14
    Views
    3,311

    Thanks, guys. I measured the voltages at several...

    Thanks, guys. I measured the voltages at several locations while the ignition circuit was hot:
    Battery: 12.42 Volts
    Coil (across positive and negative poles of coil): 0 Volts?!?
    Coil Positive to...
  6. Replies
    14
    Views
    3,311

    CJ3A Starting Problem - Runs fine once started

    Good Morning,
    My name is Chris and Iím new to your forum. Over the past eight months Iíve been doing a frame off restoration of a í51 CJ3A (serial 451-GB1 23480) with the help of the forum as a...
Results 1 to 6 of 6