Search:

Type: Posts; User: bmorgil

Search: Search took 0.00 seconds.

  1. Thread: And so it goes

    by bmorgil
    Replies
    8
    Views
    1,274

    The torque spec for the nut is 29 to 35 ft lbs....

    The torque spec for the nut is 29 to 35 ft lbs. The stud goes in finger tight with sealant on the threads.

    Perfect idea on the bore brushes! I have some small engine brushes that I use. I never...
  2. Thread: And so it goes

    by bmorgil
    Replies
    8
    Views
    1,274

    Humpty, Drain the water down well below the stud...

    Humpty, Drain the water down well below the stud hole. You want those threads clean and dry. Very clean. After a thorough brushing with solvent, I use cotton swabs and rubbing alcohol until they come...
  3. Thread: And so it goes

    by bmorgil
    Replies
    8
    Views
    1,274

    Humpty, I am pretty sure that stud is wet...

    Humpty, I am pretty sure that stud is wet (drilled through) this is how they were made on the L head block. I will bet it is the same on the F head block. You need to seal that thread that's all, if...
Results 1 to 3 of 3