Now thats funny ....I did that already as I put that last diagram up somewhere and now I can't find it. I hear Ya! :)
3594
3595
Thanks again.
Type: Posts; User: Btroy
Now thats funny ....I did that already as I put that last diagram up somewhere and now I can't find it. I hear Ya! :)
3594
3595
Thanks again.
Update as I hate to leave threads unanswered.
Success finally..:)
I was able to get my 53 running after a complete refresh and conversion.
I followed the wiring diagram but not sure if I...
Thanks for the diagrams, I am pretty sure its wired correctly as I followed the new wiring diagram I got with the hasness, I will verify once again.
Thanks for your time really appreciate this.
Can someone tell me the minimum wires I need to start the engine?
Wondering if the plug wires are correct as I whitched to 12 volt system.
Currently I only have the negative side of the coil...
That has changed, I went ahead and bought a distributor from our host with the electronics
In it.
It appears I maybe burning up
The coils. Now when I test the secondary
It is showing 9.9 on...
Ok new coil and I get spark with it as in drawing.
But when I connect up the wires
It cranks but no fire from the coil tower now?
Ok looks like the new coil is bad, as from + to - it measures 03.4. From center to - my meter does not move.
I will get another coil.
Thanks for your assistance. Will reply once I get another...
I went ahead and bought a new electronic distributor from our host. I am still not getting any spark.
I have a flame thrower coil. The instructions say it has to be an internal resistor type or I...
Cap was removed and rotor is turning CCW as expected.
Also measured voltage on negitive side of coil while cranking and it is thwe same as the postive side 9-8 volts.
Hi guys I'm back on my 53 Willys truck project.
Got the motor back together and have fuel but no spark. I converted to a pertronix but can't figure out why I'm not getting any spark.
With the...