Search:

Type: Posts; User: soutdere

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    798

    F-head Motor in Truck

    I recently purchased my '52 truck and am trying to research all I can about the motor that is in the truck. It is an in-line 6 cylinder. It is not the flathead 'Super Hurricane', I don't think. This...
  2. Replies
    2
    Views
    1,248

    This is extremely helpful. I just got a new fuel...

    This is extremely helpful. I just got a new fuel pump on it and now that it is running, my attention can go to other areas...like seats. Thanks again.
  3. Replies
    2
    Views
    1,248

    Willys Truck Seats

    I am working [perpetually] on this '52 truck of mine and am headed to the interior. The seat 'frames' are original with the springs etc but they are not mounted to anything and there is not a stitch...
  4. Replies
    2
    Views
    1,231

    When I went through my 2A, all I had was the old...

    When I went through my 2A, all I had was the old tub to estimate/measure off of. I cut some holes, and then burred them out to fit once the tub was bolted in place. It does not look pretty. The rods...
  5. Replies
    1
    Views
    1,412

    Different axle widths

    I recently bought my fist Willy’s truck. 1952. I had noticed that the front axle width appeared narrower than the rear axle width. Tires are all the same size. Using a tape measure, I measured from...
  6. Replies
    7
    Views
    2,123

    Thanks for the responses and opinions. I am...

    Thanks for the responses and opinions. I am partial to the 6v system. I converted the 2A to 12v because it was very simple. This truck is not overwhelmingly complex itself, but I am leaning toward...
  7. Replies
    7
    Views
    2,123

    '52 Willys Truck new to me

    Hello all. I just picked this truck up and am excited to begin another Willy's build. My first was a few years ago when I brought a '48 CJ-2A out from underneath a cottonwood in central Colorado. I...
Results 1 to 7 of 7