Search:

Type: Posts; User: TJones

Search: Search took 0.00 seconds.

  1. Replies
    85
    Views
    7,681

    Is you want to run 1/8” or 3/16” copper you could...

    Is you want to run 1/8” or 3/16” copper you could use either 1/8”or 3/16” compression or a flared fitting and run it from the block to the gauge with the right adapters.
  2. Replies
    85
    Views
    7,681

    Doug, don't buy one.. I have exactly what you...

    Doug, don't buy one..
    I have exactly what you need then, I ordered my speedometer from "Southwest Speed" and they sent me a cable with the speedometer by accident and when I called them they said...
  3. Replies
    85
    Views
    7,681

    Here you go dougl 5416 It’s on eBay

    Here you go dougl


    5416

    It’s on eBay
  4. Replies
    85
    Views
    7,681

    We’ll find you one I’m sure, I’ll start looking...

    We’ll find you one I’m sure, I’ll start looking around!!!
    Worse comes to worse you could always drill the one you have and cut a slot in it to make it work.
  5. Replies
    85
    Views
    7,681

    Dougl it is pretty simple to take out, just...

    Dougl it is pretty simple to take out, just loosen the 7/8 nut and pull it off and the pencil gear will pull right out so you can look at it and you’ll be able to see which cable end you have. You...
  6. Replies
    85
    Views
    7,681

    Here is what is in my Dana 18 for speedO drive...

    Here is what is in my Dana 18 for speedO drive and cable

    539853995400
  7. Replies
    85
    Views
    7,681

    I will post a picture of mine later, as soon as I...

    I will post a picture of mine later, as soon as I get my last minute Christmas shopping done!!!!
  8. Replies
    85
    Views
    7,681

    DougL; I had to buy a different speedo cable...

    DougL;

    I had to buy a different speedo cable as well, the little lip on the end slides in a slot on the transfer case pin to drive the speedometer. If you need one that is square on both ends, I...
Results 1 to 8 of 8