Search:

Type: Posts; User: 51 CJ3

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    2,519

    Nevermind, I got frustrated enough to get the...

    Nevermind, I got frustrated enough to get the acetylene torch after it and make it glow. At that point it moved a quarter of an inch with a little prying. I was using a can of electronics dust...
  2. Replies
    15
    Views
    2,519

    Tornadoes gone for now. Back work. I got the...

    Tornadoes gone for now. Back work. I got the bearing cups out but the transfer case front output shaft bearing is seized in place. I managed to rip the bearing cage off of it but the race is still on...
  3. Replies
    15
    Views
    2,519

    Getting it. Had to use the press again. Bearings...

    Getting it. Had to use the press again. Bearings are stuck on the shaft. Tornado warning slowing progress now.
  4. Replies
    15
    Views
    2,519

    It did have water in it as did the transmission...

    It did have water in it as did the transmission and front differential. The previous owner was a kid who thought it was fun to play in the river but never gave a thought about maintaining his ride. ...
  5. Replies
    15
    Views
    2,519

    I couldn’t get it with a hammer and punch even...

    I couldn’t get it with a hammer and punch even with heat. Ruined a good brass punch though. It had to go to the press which had it out in seconds. Bearings and shaft are pretty chewed up.
  6. Replies
    15
    Views
    2,519

    Transfer case disassembly

    I am finally turning my attention back toward the CJ3A. When I got distracted I was trying to disassemble the transfer case to replace the bearings. Is there a trick to getting the center shaft out?...
Results 1 to 6 of 6