Search:

The best thing I found to remove paint from darn near anything are the abrasive nylon brushes sold by Horrible Freight. Bmorgil referred to these brushes earlier in discussion with finding the...

The starter and generator are back installed. The starter ended up having a bad switch, even though I replaced it a couple of years back. I searched through my hoard and found the original one to...

I like the F head constipation. Good one LarrBeard!

The oil is a good sign. Hopefully the fuel and coolant were drained to prevent fuel getting old and the coolant from being under strength. Rubber hoses are cheap to replace compared to leaking fuel...

Speedo cables are a maintenance item that nobody thinks of. I went through a couple of speedo cables before I found a good source of NOS cables. So far, and a few years later, it's still working...

Work and life has a tendency to steal time away from projects. It happens. Yesterday was the first day that the Heep has seen daylight in a long time, awaiting the starter and generator to come...

7,500 rpm on the bottom end would definitely make for an oil pan failure. '56, your welds look a lot better than the ones on that intake.

black soot is much better than coolant/rust. As you imply, a carb adjustment is much easier than the alternative.

Amen to that Bmorgil. You can tell that '56's folks did a great job in bringing him up, and instilled a great work ethic in him to boot.

You are well on your way in getting started AJ-MJ. We look forward to tagging along in your progress. 1995 doesn't seem to be that long ago, but it is almost 30 years ago.... Holy cow. But anyway,...

Well said '56.

Usually if you have noise when deceleration, that often tells you that you have excessive backlash on the ring and pinion on the differentials. Dr. Dana can elaborate more on that subject. It isn't...

There is typical more than one way to do things besides right or wrong. I would sure try to loosen the main caps to sneak the new seal out. That will save you some time.

The next question is if the hot rod Kaiser Supersonic head was put on at that time or later on.

Thank you to all who didn't make it home

The Jerry can idea is an awesome idea '56, but like '51 said, you'd have to vent the top of the tank to flow correctly. The Jerry can would be the least intrusive way to extend your milage, and the...

Are you 100% sure that it is engine oil? After I do a service on the Heep, the transmission leaks out the front seal until it seeks the level it likes. It leaks at the bell housing. Just a thought.

Information is pretty limited on the Mustang Rebuilders Inc. There are a few adds on eBay that are dated in the early '60s.

https://www.ebay.com/itm/175657582909

The address leads to a...

Unfortunately, you can only upload one photo at a time into the attachment manager. Once it's in your manager, you can add four more photos for a total of five.

Not on pavement. I know I locked up the rear 11" drum brakes on the wagon, thirty years ago when a car pulled out in front of me. They were way too close, so I locked up the brakes for a brief...

Great to hear that she is running like a sewing machine. Great tech tip on the 24 volt/ waterproof distributor timing process.

Fantastic outing! Well done '56. Flossy looked great out with Grampa's Corvette and your Dad's truck.

Rear main seals were originally rope:...

The views are definitely increasing TJ. It is interesting to see what folks are looking at. The last time I looked, it was heavy on M38A1 related material to include Pelagro. Today it's all over...

I'll probably spend a lot of my free time doing research on the subject tonight. I'm interested to find out myself. The possibilities are endless at the moment

Way to go 56. We are proud of your progress and your drive. You'll have some Gremlins to handle with the electrical grounds, but that's not bad for how quick it all came together. I would top off...