If the FC-150 is a Mugly Other, the FC-170 is a Big Mugly Other.
Type: Posts; User: LarrBeard
If the FC-150 is a Mugly Other, the FC-170 is a Big Mugly Other.
Did you have it stuck back in a box that you hadn't searched through, or did you find a source for it somewhere?
That lil' D12 is so freakin' cute. It looks like a tractor only a lot smaller.
Keeping Our Cool - Revisited
In the last post on this I made the comment: "Now I just need to change out that dripping, pizzling cheap plastic radiator drain plug with a real brass petcock –...
After sitting 40-years, I suspect you are going to find a lot of seals that leak. The '48 truck sat 35-years and we just replaced every seal we saw. And - even so, I've had to replace a couple that...
Like the "Bull of the Woods", it lows at people to let them know "You're the Boss".
Does anyone else remember that chewing tobacco commercial?
One of the biggest tasks in recreating an original M38 will be duplicating the 24-volt electrical system. The major components are available, but expensive. You will have to decide just how deeply...
No - I never found any replacements for those strange u-joints and other stuff. The joints and boots are good, so I'm holding off on any driveline projects just now.
We discover more and more...
Just FYI - the Milodon packaging does say "Made in USA".
Rack up another win for Doc Dana!
Keeping our Jeeps cool is always a concern, especially if we drive them in parades where the pace is slow and the temperature on the asphalt gets hot. BMorgil...
" My 11" brakes off a 46 Pickup do not have the bottom adjusters, maybe Larrbeard can jump in...
Do your brakes only have adjusters on the top Larry?""
Yes, I have 11-inch brakes. The '48 only...
I was reviewing the thread and I caught a note from back in February:
"... installed a new fuel filter between the gas tank & fuel pump - hopefully this does the trick & will keep you posted!"
...
Nice tack and stitch technique. Are you using a heat sink backer?
The two screws that act as contacts have shoulder wshers (insulating washers) to isolate them from the case. Make sure they are there and working. If the screw that goes directly to the battery...
As I said earlier in the week:
"I firmly believe that no matter how good an old Jeep looks to viewers, the owner always knows that there is just “one more” thing that needs to be improved on. "
...
Gee, thanks for bringing that to my attention.
The FC-series trucks were similar in concept to the original Ford Econoline vans; get the most cargo space as possible for a given wheelbase. You...
Fuel filters in the tank seem like a good idea until you realize that if they do their job, sooner or later, they are going to clog and need replacement.
I'd suggest you add a new filter between...
Yep, same thing in airplanes...
One of my favorites is the one undersized pin that won't lock into the backshell and then backs out when you engage the connector
Yesterday turned out to be one of those early Spring Days that just makes you go out and work on the Jeep. I fixed the horn wire problem and then I turned my attention to the differential oil leak. ...
I know you've been there and chased that ... trying to pull crimped contacts out of a 57-pin MS Connector to get to the one wire you need to look at. Our Engineering Assembly Shop cable ladies...
I firmly believe that no matter how good an old Jeep looks to viewers, the owner always knows that there is just “one more” thing that needs to be improved on. Ham’s ’48 is certainly in that...
I firmly believe that no matter how good an old Jeep looks to viewers, the owner always knows that there is just “one more” thing that needs to be improved on. Ham’s ’48 is certainly in that...
He really did get all of those pieces back in the housing!
[QUOTE=bmorgil;16188]Check this out. Sealed auction starting at $10,000. Bidding till April 2nd. Nice old Willys. I wonder what it will go for? I am guessing well out of my budget!
It's nicer...
Some homeowners policies have a "mysterious disappearance" clause, but you're probably not to your deductible to meet that...