Is you want to run 1/8 or 3/16 copper you could use either 1/8or 3/16 compression or a flared fitting and run it from the block to the gauge with the right adapters.
Type: Posts; User: TJones
Is you want to run 1/8 or 3/16 copper you could use either 1/8or 3/16 compression or a flared fitting and run it from the block to the gauge with the right adapters.
Doug, don't buy one..
I have exactly what you need then, I ordered my speedometer from "Southwest Speed" and they sent me a cable with the speedometer by accident and when I called them they said...
Here you go dougl
5416
It’s on eBay
We’ll find you one I’m sure, I’ll start looking around!!!
Worse comes to worse you could always drill the one you have and cut a slot in it to make it work.
Dougl it is pretty simple to take out, just loosen the 7/8 nut and pull it off and the pencil gear will pull right out so you can look at it and you’ll be able to see which cable end you have. You...
Here is what is in my Dana 18 for speedO drive and cable
539853995400
I will post a picture of mine later, as soon as I get my last minute Christmas shopping done!!!!
DougL;
I had to buy a different speedo cable as well, the little lip on the end slides in a slot on the transfer case pin to drive the speedometer. If you need one that is square on both ends, I...