Search:

Type: Posts; User: Allen

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    15,433

    Thanks. This gives me renewed hope that this...

    Thanks. This gives me renewed hope that this could be the fix I need.
  2. Replies
    8
    Views
    15,433

    Thanks I’ll start in with the distributor then....

    Thanks I’ll start in with the distributor then. Would replacing the bushings fix the 3/8 up and down play or should I just buy a new one from KW?
    The coil was installed last year when I converted to...
  3. Replies
    8
    Views
    15,433

    Thanks for the suggestions. I am still having the...

    Thanks for the suggestions. I am still having the same issue after installing new spark plug wires points and condensor.
    I’ve also tightened and sealed vacuum lines.
    I checked the distributor...
  4. Replies
    8
    Views
    15,433

    Engine stalls at speed and restarts

    I’ve got a 54 M38A1 that stalls while cruising on the highway and within a sec or two powers up again. It has a clean fuel tank, new tank filter new inline filter new fuel pump and rebuilt...
  5. Replies
    3
    Views
    33,807

    How to remove axle shaft?

    This is a ‘54 M38A1 that I am trying to change inner seals and bearings on the rear axle. I’ve watched videos but don’t know which apply to me. Is this axle shaft press fit and I use a puller or is...
  6. Thread: 6 12 or 24 volt?

    by Allen
    Replies
    1
    Views
    28,564

    6 12 or 24 volt?

    I have a M38A1 from 1954 with a CJ5 grill and 6 volt electrical system that I just bought. I want to install all the A1 lights and gauges that are 24v. Should I convert back to 24v, convert to 12v or...
  7. Replies
    2
    Views
    6,014

    New owner, old jeep

    I’m Allen and live in Western NC. I just bought what I thought was a 1954 M38A1 and upon closer inspection am finding components of a 1956 CJ5. I found serial numbers of both on the vehicle. It...
Results 1 to 7 of 7