Search:

Type: Posts; User: danielbaldwin

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    32,349

    Outstanding ! Thank you for the schematic's......

    Outstanding ! Thank you for the schematic's... I'll look into the alternator. I appreciate your input. dan baldwin
  2. Replies
    2
    Views
    32,349

    Ammeter vs. Volt gauge

    I have a '48 Willys with 12 volt conversion. It currently has a ammeter gauge that is virtually useless. It always registers the same reading, even when the starter was shorted out or the battery was...
  3. Replies
    3
    Views
    6,277

    LarrBeard: Well, do I feel like a dummy !!! After...

    LarrBeard: Well, do I feel like a dummy !!! After reading your great directions, I went back out and rechecked the voltages. I quickly realized that I had a good 12.5 volts D.C. between the battery...
  4. Replies
    3
    Views
    6,277

    No Electrial. Dead??

    I have a 1948 (46?) Willys CJ2A. I restored/rebuilt the engine last year and all is fine. runs great. However, last week I left the headlights on after i turned it off, and the battery went dead. I...
  5. Replies
    2
    Views
    5,530

    Milk4you: I have a 14811481 '48 CJ2A with an...

    Milk4you: I have a 14811481 '48 CJ2A with an unusual Left side spare tire. While it is approx. the same size as the four mounted tires, it has never created any problems
  6. Replies
    3
    Views
    6,741

    Well, inspecting a jeep is pretty much the same...

    Well, inspecting a jeep is pretty much the same as any other car. I would look under the frame for obvious rust under both drivers and passenger side as well as rear. Does the jeep run? Brakes...
  7. Replies
    5
    Views
    10,577

    thanks for the information. I'll try what you...

    thanks for the information. I'll try what you suggested. However, knowing virtually nothing about transmissions and transfer cases, how is it possible that the transfer case could be causing the...
  8. Replies
    2
    Views
    5,010

    if you haven't already got it, by all means you...

    if you haven't already got it, by all means you must order a "service manual" before doing anything. these are great and will guide you throughout your project. dan
  9. Replies
    5
    Views
    10,577

    Transmission Problem

    I recently completed a complete engine rebuild on my 48 CJ2A. all is finally well with the rebuild, but now i have discovered that the vehicle will NOT move in 2-wheel drive. It acts like it is stuck...
  10. The single piece windshield and location of gas...

    The single piece windshield and location of gas tank filler SEEMS to indicate a CJ3A Probably post 1949.
  11. Replies
    4
    Views
    8,144

    Never mind. I figured it out. Turns out I had the...

    Never mind. I figured it out. Turns out I had the input leads to the coil backwards..... who knew that a round coil will fit into a round bracket and rotate 360 degrees? When I removed the old coil I...
  12. Replies
    4
    Views
    8,144

    Starting (coil-spark) Problem

    I recently purchased a '48 CJ2A. After having the engine professionally rebuilt it will not start as it did before the rebuild. It has been converted by previous unknown owners to a 12 volt...
  13. Philip, that worked just fine. thanks for the...

    Philip,

    that worked just fine. thanks for the advice. dan B
  14. Thank you. I'll try that. However, I don't see...

    Thank you. I'll try that. However, I don't see how removing the front motor mounts will allow the engine block to lower. The mounts are bolted to the frame on a slanting, diagonal brace that is...
  15. Accelerator (gas) pedal linkage to Carb ????

    After rebuilding my 48 CJ2A engine 4-134 flat head, I finally got the engine reinstalled. However, when I tried to reconnect the accelerator (gas) pedal linkage, it appears that the linkage from the...
  16. Replies
    0
    Views
    31,578

    Accelerator (gas) pedal linkage

    After rebuilding my 48 CJ2A engine 4-134 flat head, I finally got the engine reinstalled. However, when I tried to reconnect the accelerator (gas) pedal linkage, it appears that the linkage from the...
  17. Replies
    3
    Views
    5,827

    Did you look up the vehicle I.D. on the firewall...

    Did you look up the vehicle I.D. on the firewall plate yet? The early '46's had a chain drive timing gear, later models used a gear drive timing gear. I notice that the gas tank does not have the...
Results 1 to 17 of 17