As always, I appreciate the info you guys give.Originally Posted by gmwillys
Ok, here's another problem I just discovered yesterday. When I put the head on I couldn't find any clear cut way to install the head gasket or wither or not to use any sealant. I wound up putting the folded side up without any sealant. Yesterday I noticed water leaking out between the head and block. I followed the steps to tighten the head bolts. Even done it again a couple of times the next day. It even said when it gets to running temperature to recheck the head bolts and tighten again if needed. At this point, what would you guys do?
At least I am learning something as I go along this journey. Even thou it is the school of hard knocks.
Reply With Quote