Results 1 to 2 of 2

Thread: Mb/carter ys carb question

  1. #1

    Mb/carter ys carb question

    Ok, so Iíve started pulling parts off and cleaning them on my MB project. Started with the air cleaner and air manifold. In doing so I noticed that the manifold has an air nipple badly welded in to it about 3Ē from the air cleaner. There was an air line ran from this nipple to the upper rear of the carb where a factory port, but relatively new air nipple is. Does this sound correct to you folks? It doesnít look right to me, the manifold itself needs some attention, but the weld definitely looks joe-blow garage mechanic, and I donít see why there would be a second air line running to the carb behind the butterfly valve. Itís all apart now but this is a picture from before cleaning and disassembly.
    Attached Images Attached Images

  2. #2
    hello. check the link below
    https://www.hemmings.com/magazine/hc...w/1281014.html
    good look

    LM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •