-
Super Moderator
Jeff do you have the output clutch gear in there? Just to be sure, the output gear should be against a thrust washer and a snap ring. Then the output clutch gear slides on. #37 snap ring is the ring that goes on the bearing O.D.. The thrust washer is item #44 and the snap ring that holds it there is #43. Then the clutch gear #42 goes on. Until you get the cap on and shimmed up, things will be out of position. So yes things will need to be moved around a bit to get it together. It is a little tricky, but you just need to tap the bearings around to get everything to to stay together while you assemble it.
Last edited by bmorgil; 08-25-2022 at 04:25 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules