Results 1 to 10 of 127

Thread: The Frankenjeep

Threaded View

  1. #24
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    2,938
    Jeff do you have the output clutch gear in there? Just to be sure, the output gear should be against a thrust washer and a snap ring. Then the output clutch gear slides on. #37 snap ring is the ring that goes on the bearing O.D.. The thrust washer is item #44 and the snap ring that holds it there is #43. Then the clutch gear #42 goes on. Until you get the cap on and shimmed up, things will be out of position. So yes things will need to be moved around a bit to get it together. It is a little tricky, but you just need to tap the bearings around to get everything to to stay together while you assemble it.
    Last edited by bmorgil; 08-25-2022 at 04:25 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •