Results 1 to 4 of 4

Thread: ‘65 CJ5 bogging/stalling out

  1. #1
    Junior Member
    Join Date
    Sep 2017
    Posts
    4

    ‘65 CJ5 bogging/stalling out

    Hey y’all,
    As the title implies I am having some issues I could use some help solving. Fuel pump was replaced last year as was the tank and the carb is only a few years old. New plugs, points, and condenser as well. It seems to be once it is warmed up, it will choke itself out at speed (will also do this at idle but has only done so once or twice). Once I let it breathe a little, it will start back up and I have another five minutes or so before it repeats the process. I am going to replace the fuel filter as a simple fix and see if that helps. Maybe running too rich at speed? Any ideas would be greatly appreciated!

  2. #2
    Senior Member
    Join Date
    Jan 2015
    Posts
    181
    Sticky float? Float out of adjustment? Float sunk? Just throwing out possibilities for too much fuel. I would expect a more consistent problem if the needle valve needed adjusting but it could be a possibility too.
    Last edited by 51 CJ3; 05-30-2018 at 05:15 PM.
    Jeff
    '51 CJ3A
    '47 CJ2A

  3. #3
    Junior Member
    Join Date
    Sep 2017
    Posts
    4
    Thanks Jeff! I noticed last night that the choke cable that I installed over the winter wasn’t letting the choke all the way out. Gave that an adjustment and seemed to do better. It did stall out on me again but with rain on the way in I wasn’t able to give it a full run through. Going to adjust the carb tonight and see if that helps. If that doesn’t then I will look into the deeper fixes on the carb.

  4. #4
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    1,624
    With the issues coming about after the engine is warm, check the timing as well. A tach and dwell meter is worth the investment to ensure the points are set to spec. Another fuel related thing to check would be that the supply fuel line is not too close to the exhaust. The fuel may be vapor locking, causing the supply issues. If exhaust temperatures are high, then check back with the timing.

    If all the above checks out, then perform a compression test cold, then again warm. A sticking ring will drop compression as the engine warms.
    Last edited by gmwillys; 05-31-2018 at 08:01 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •