Results 1 to 2 of 2

Thread: Dana 18 Transfer case question

Threaded View

  1. 10-09-2018, 07:44 AM #1
    steve.barnett71
    steve.barnett71 is offline
    Junior Member
    Join Date
    Apr 2018
    Posts
    5

    Dana 18 Transfer case question

    The jeep I inherited is a 1960 M38A1, at some point the drive train from a CJ5 was put in it. The e brake does not match up to the linkage of the M38A1 body. I have ordered all the parts to replace it with the military style e brake. This includes replacing the rear bearing housing of the transfer case. The old bearing housing did not have any shims under it to adjust the end play of the output shaft. Since I am not replacing bearings is there any need to measure and adjust the endplay? Would I be safe to put the new housing on without shims?
    Last edited by steve.barnett71; 10-09-2018 at 07:53 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules