Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Champion Radiator in a CJ3A

  1. #21
    Senior Member TJones's Avatar
    Join Date
    Apr 2018
    Location
    Akron, Ohio
    Posts
    1,150
    I was a little taken back from Griffin when she said 800-1,200 as well especially after I told her it wasn’t a Keith Black Blown Hemi putting out 4,500 HP we were dealing with here, she said “it is what it is”.
    It should fit perfect, I gave them the exact measurements of what I have now.
    I guess we’ll see in 5-8 weeks when it arrives!!!
    Last edited by TJones; 07-08-2019 at 06:49 PM.

  2. #22
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    3,559
    Now I remember why I was good at fixing my old busted up mopar rads. One was twisted four inches rearward at the top left, with the upper nipple pushed through the front of the top tank. The lower right side was pushed forward six inches. After an hour in the press, and some peening out the top tank, it actually held descent pressure when tested. Smart folks run the radiator in the rear, in front of the trunk. I never liked boiling water that close to my back side.

    The Champion is a no brainier. Even I might invest in the Champion for the wagon project.
    Last edited by gmwillys; 07-08-2019 at 07:52 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •