-
Junior Member
Carter yf 1bbl carburetor 2476s rebuild
INFO ON REBUILDING. ESPECIALLY CONCERNING NEEDLE/SEAT.
1) CARBURETOR REBUILD KIT IS BWD 96-103A/ STANDARD 121A
2) THE SUPPLIED NEEDLE AND SEAT IN THE KIT WILL NOT WORK IN THIS CARB. THE CORRECT NEEDLE AND SEAT COMBO WAS NOT READILY AVAILABLE THROUGH REGULAR DISTRIBUTION.
3) IF POSSIBLE REUSE THE EXISTING NEEDLE AND SEAT COMBINATION.
4) CORRECT REPLACEMENT N/S CAN BE ORDERED ON-LINE AT MIKE’S CARBURETOR PARTS # NS502. IT CONSISTS OF ONE SEAT AND TWO NEEDLES. I USED THE LONGER OF THE TWO NEEDLES. NEEDLE DOES NOT COME WITH CLIP (NOT NEEDED).
5) THIS CARB DOES NOT USE THE SPRING AND BALL SET UP FOR THE ACCELERATOR PUMP CHECK VALVE. IT USES A NEEDLE VALVE (FOUND IN KIT).
CARTER FACTORY INFO ON THIS CARBURETOR CAN BE FOUND AT
http://www.jeepsurreygala.com/?page_id=979
Individual components for this and other makes and models of carbs can be found at www.walkerproducts.com
Last edited by pdudleystl; 02-18-2020 at 02:51 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules