Results 1 to 8 of 8

Thread: The Right Motor Oil

Threaded View

  1. #1
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    3,840

    The Right Motor Oil

    There is a lot written on the WWW about what oil to use in your classic vehicle. There are two important things you should do. First stick to the SAE weight specified in the service manual. The weight of oil you use in anything depends on the engineering requirements for the operating temperature of the oil. So the hotter you run the oil, the thicker it must be. This is why you see such high weight oils used in Racing where the oil can exceed 300 degrees. For the little 134's if the Ambient temperature is not going to be lower than 32 Deg F, the weight recommendation is 30W. If it is going to be colder than 32 but not under 10 the service manual recommends 20W. If it is going to be -10 the recommendation is 10W. Finally if it gets colder than that, 5W. Second it needs to have a high wear additive (ZDDP). So a good High ZDDP 10W-30 will work well for most of us. The 10W indicates additives that make it work in the cold environment needed for 10W, as well as the warmer weather 30W requirement. No need to worry about multi viscosity or straight weight, either will do as long as the SAE weight is there for the ambient temperature. The "cold weight" number (the 10W in 10W-30) is the additive package extending the range of the oil.

    So for mine I use Valvoline VR1 10W 30. This is about the highest load capable, high ZDDP street-able oil I could find. It proves out on top in testing. One of those can't go wrong oils. There are a few brands however that will work just fine.

    The most important aspect of the oil in a classic flat tappet engine is the amount of Zinc it contains (ZDDP). There are two things that need attention. The camshaft lifter design requires a high wear protector (Zinc). The low oil pressure inherent at idle, requires a high film strength. Finally if the engine sets a lot, a good anti-rust additive.

    I would not use the synthetic version of VR1 or any synthetic. You would have to be very sure the piston rings and cylinder finish, seals, gaskets and sealants are compatible, before considering synthetics. Most oils intended for Diesel applications have ZDDP wear additives. They usually have way to much detergent for a gasoline engine however. This can cause foaming in the higher RPM environments of a gasoline engine, and starve the bearings. If you use a diesel oil, you must be sure it is compatible with Gasoline engines. There are some combination Gas/Diesel oils out there.
    Last edited by bmorgil; 06-05-2021 at 07:13 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •