Yes, I bought a new speedometer and gauge cluster. I wired it like it showed. There is a jumper that goes from the fuel gauge to the temp gauge that supplies 12 volts. It already had an electronic sender. I can run a jumper from the sender side to ground and the gauge doesn't move, but then if I tap on it some, it will move up to about 1/4 so it seems to be stuck. Unhook the jumper and tap and it will go back to low. Another thing that happened was that I was hooking up my lights and trying to get that all straightened out and noticed when I had the lights on the fuel gauge would work better. The battery was a little low and it was getting under 12 volts with the lights on, so I'm thinking the problem with the fuel gauge is too much voltage.