Nevermind, I got frustrated enough to get the acetylene torch after it and make it glow. At that point it moved a quarter of an inch with a little prying. I was using a can of electronics dust remover trying keep the shaft cool. Made it glow again and got another sixteenth which was enough to catch it with a bearing separator and pull it the rest of the way. I had to use the press to get the rear bearing cup and the separator to get that bearing too. Used my big slide hammer to get the front bearing cup. Next up is the clip but I don’t have a proper snap ring tool for one that style and size so it looks like I get to go tool shopping. Fortunately, I know where the $nap-on truck will be about 10 tomorrow morning.