Question about T18 transfer case mounting to cross member
How do the rubber bushings go when mounting T18 case to cross member. First of all I had two separate frames . Supposedly a cj2a and a cj3b. The fitting where the rubber bushing goes into the round mounting attachment welded to cross member on the cj2a did not have a metal bushing in it as in first pic. The cj3b crossmember had a metal bushing in not allowing the rubber baby buggy bumper bushing (say that real fast ) not go in, so removed the ring . But my question is the small bushing really suppose to go under the bigger bushing. Both frames had engines attached but upon removal of transfer case the small rubber mounting bushing was under the cross member. Does any one know proper orientation of said mounting of rubber bushings ? Last pic is how I think they should go. Pic 3 should be first. I may be wrong about the small rubber isolator it maby should go underneath, so that bolt wont pound from underneath. Getting confused by the metal parts in isolators dont really look like they are the same part, the new isolator upper has a metal top imbedded in the rubber, mabey the ring is also imbedded in it .
Reply With Quote