Good day, all --

I was thinking about removing some of the leaves (leafs?) from the spring packs on the old 3a. A few at each corner. The idea is to tame the ride a bit for the old backside and associated bits n pieces...

Should I be working from the bottom up? Take a couple from the middle? Other approaches? I assume I have to pull the entire thing out to disassemble but if it's possible to just jack the frame up til everything relaxes, loosen the u-bolts, pry open the bands etc and bang each leaf out I'd do that instead.

(Also, the poor girl has a bit of a list to port when sitting empty...perhaps take one more out of the starboard sides front and back to compensate and lower that side a bit more?)

Lotsa question marks I know