Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: cylinder head question - Never saw this before

  1. #11
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    3,839
    Take em' to the shop John. While they have them, ask them to boil them clean and check them for flat. If the threads need repair they will have the stuff right there.

    Or, soak them in penetrating oil and use heat. A lot of heat. Turn the fouler a little red. Quench it in wax. Last resort is to continue to drill until you can take a small chisel and collapse the drilled thin wall inward and pick it out of the threads. You definitely want to avoid ruining the threads in the head. If you do, a thread insert will fix it. The biggest danger is drilling it off center. If that happens just don't drill to big. Cut it down until you can start to carefully chisel it out.

  2. #12
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    3,786
    John,

    No such luck. I still have the same engine in our Heep that was in it when it was purchased. My Granddad had it for a while for use on their farm, and he went through and replaced the one piston that had a hole in it, then freshened up the bearings and rings. He didn't believe in spending more than one had to perform repairs. He passed in 2003, so it was done some time in 2001 or early 2002, but it has been smoke free ever since.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •