Page 1 of 5 123 ... LastLast
Results 1 to 10 of 49

Thread: 1954 CJ3B - Project

  1. #1
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53

    1954 CJ3B - Project

    Day 1 - I pulled the spark plugs and all 4 were dry, black and sooty. I guess it was running rich 30 years ago. Added Marvel Mystery Oil. Then I started taking off the tow bar, CB, speakers and rear spare tire carrier. I think I cut off about half the screws & bolts I removed. Vacuumed up a lot mouse stuff etc.

  2. #2
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    3,782
    black soot is much better than coolant/rust. As you imply, a carb adjustment is much easier than the alternative.

  3. #3
    Senior Member 56willys's Avatar
    Join Date
    Jan 2023
    Location
    Northwestern PA.
    Posts
    333
    Those rusty bolt gremlins seem to strike on everything. Nothing worse then making a five minute job take five hours because a bolt broke off. Firm believer in never-seize.

    I've heard good things about mystery oil, however if it doesn't work, I used some automatic trans fluid in my spare motor. And it seemed to work well. I would check your oil pump before trying to turn it over too much. The pump on mine was seized and when I got the cam to turn over it stripped the gear. Just a couple things to be mindfull of.

    Glad to see your back working on the project, looking forward to updates!

  4. #4
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    3,819
    Good stuff there 56'. The oil pump, what a disaster!

    AJ-MJ Black soot on the plugs is as gm said, much better than anything else. I would say probably idling with the choke on before she got shut down the last time. That said, I have yet to pour gas into a 30 year old carb and have it function as designed. But, miracles never cease! That said, I have had a few motors that set for a long time, that with a carb rebuild ran just like the day they shut down.

  5. #5
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53
    Thanks for all the tips and encouragement. I am taking a little R&R and plan to get back after the jeep on Tuesday. I'll post some pictures when I figure that out. THANKS AGAIN!

  6. #6
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53

    Projects

    Here is a couple of pictures of the 3B
    Attached Images Attached Images

  7. #7
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53

    Smile Engine

    I know there is a lot of discussion about what color is the engine. WELL, I got a blue one
    Attached Images Attached Images

  8. #8
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53

    Engine Number

    Any suggestion on reading the numbers... I guess when I pull the radiator I might be able to see it a little better.
    Attached Images Attached Images

  9. #9
    Member AJ-MJ's Avatar
    Join Date
    Jan 2021
    Location
    Hopewell, Virginia
    Posts
    53
    A couple more observations:
    The oil was right at the full mark, dark but felt normal
    No coolant in radiator
    No gas in the gas tank
    Every thing that is rubber is hard and brittle
    There is a bolt on the fender at the battery. Did 3B have a battery hold down?

  10. #10
    Super Moderator gmwillys's Avatar
    Join Date
    Aug 2017
    Location
    Alabama
    Posts
    3,782
    The oil is a good sign. Hopefully the fuel and coolant were drained to prevent fuel getting old and the coolant from being under strength. Rubber hoses are cheap to replace compared to leaking fuel or coolant on the ground.

    The battery hold down should mount to the battery tray with two J hooks, but even our Heep has a wing nut on the inside of the fender well, but it doesn't align with the battery. The MB had a strap that mounted to the fender, but that's the only one I knew for sure.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •