Results 1 to 1 of 1

Thread: Rear out put shim and bearing replacement ?

  1. #1
    Junior Member
    Join Date
    May 2013
    Posts
    2

    Transfer Rear output shaft shim and bearing replacement ?

    I have a 1959 CJ 5 and my dana 18 rear transfer output shaft oil seal is starting to leak and I have a vibration in the transfer when I am coasting. With pressure on gas or off it is smooth. Just in that no load spot on the drive train is when it vibrates. I do have some play in the out put shaft up and down. This has had it since it was rebuilt.
    So my question is can I change out the bearing or just shim the bearing while in the jeep or do I have to pull transfer out to do that.

    Thanks
    John
    Last edited by Johnd; 05-17-2013 at 05:28 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •